Replacing the Belt
Required tools
Crosstip screwdriver required
1/2 inch wrench
-
Remove all equipment (breading lugs, back splash, dip pot, BELT etc.) from top of unit.
-
Remove top by lifting from unit.
-
Using a #2 crosstip screwdriver, remove two screws from cover plate assembly, and slide cover plate assembly out towards the sifter basket.
-
Using a 1/2” wrench, loosen the hex nuts on the adjustable foot so that the motor can be moved to loosen the belt.
-
Replace belt and adjust tension.
Proper tension is achieved when belt deflects approximately 1/2” (12.7 mm).
