Error Codes
Display | Cause | Solution |
---|---|---|
“E-4 CPU TOO HOT” |
Control board too hot; unit overheating or louvers clogged |
Turn switch to OFF position, then back to ON; if display still shows “E-4”, the PC board is getting too hot; clean louvers and check cooling fan; if cooling fan is not working, have it replaced; once panel cools down, the controls should return to normal; if “E-4” persists, have the PC board replaced |
"E-6B AIR TEMP SENSOR FAILED SHORTED" | Faulty air temperature probe | Turn switch to OFF position, then back to ON; if the display shows “E-6”, the temperature probe should be checked; once the temperature probe is repaired, or replaced, the controls should return to normal; if “E-6”persists, have PC board replaced |
"E-41 SYSTEM DATA LOST" | Memory scrambled | Turn switch to OFF position, then back to ON; if the display shows “E-41”, the control should be re-initialized (see Programming Section); if “E-41” persists, have PC board replaced |
Controls set CE=y means unit does not have a temperature probe and the controls must be set to CE=n in Special Programming.
Related Content
Installing the Express Profit Center (EPC) 200, 300, or 400
Operating the Express Profit Center (EPC) 200, 300, or 400
Programming the Express Profit Center (EPC) 200, 300, or 400
Troubleshooting the Express Profit Center (EPC) 200, 300, or 400
Information about the Express Profit Center (EPC) 200, 300, or 400
Reference