Replacing the Drawer Gasket

1. Remove the basket from the drawer and basket from the cabinet.

2. Remove the two screws securing the drawer handle and remove the handle from the drawer. (Location of mounting screws may vary depending on type of handle on the drawer.)

   

3. Remove the four screws securing the backing plate and gasket to the drawer front.

   

4. Separate the drawer frame from the drawer front.

5. Remove the gasket from the drawer.

6. Fit new gasket into place in the drawer front.

7. Reassemble the drawer frame and drawer front in reverse order of disassembly. Center the two drawer handle spacers over the screw holes so the handle screws pass through the spacers.

Replacing the Drawer and Liner Bearing

Apply Loctite to screw threads when replacing drawer bearing kit or liner bearing kit. If using existing hardware, clean threads of any old Loctite before applying new Loctite sealant. Perform this procedure after store closing to ensure Loctite has a chance to dry before using the cabinet. Bearings are to stay stationary, and are not to roll with the drawers.