Applies to:

Replacing the Fuse

Overview

Not all units are equipped with fuses.

Procedure

If both blowers quit working at the same time:

To avoid electrical shock or property damage, disconnect power before installing or servicing equipment. A qualified technician must perform the service procedures.

Remove electrical power supplied to the cabinet.
Remove the cap from the fuse holder by turning it counterclockwise.

Located above the power cord.
Pull the fuse from the holder.
Check the fuse for defectiveness by putting both leads of the ohmmeter or continuity light on opposite ends of the fuse. The fuse should be closed, or read no resistance. If the fuse is found to be defective, replace it with a new one. Be sure to use an identical fuse as the one being replaced.
Replace the cap to the fuse holder.
Reconnect the electrical supply to the cabinet.