Applies to:

Replacing the Power Switch

To avoid electrical shock or property damage, disconnect power before installing or servicing equipment. A qualified technician must perform the service procedures.

Using a crosshead screwdriver, remove the four screws securing the front panel.
Lower panel, remove connectors from the back, and remove panel from unit.
Using 5/16" socket, remove the 4 nuts securing the control cover and remove cover.
Remove wires from switch and check across the 2 terminals for continuity. With switch in ON position, the circuit should be closed. In the OFF position, the circuit should be open. If the switch is defective, continue with step 5.
Pinch the tabs on the rear of the switch and pull the switch through the front of the panel.
Replace with new switch in reverse order and unit is now ready for use.