Replacing the Breakers

There are two breakers on electric fryers. To reset the breaker, open the left door and push-up on the plunger of each breaker.

Checkout

To avoid electrical shock or property damage, move the power switch to OFF and disconnect power.

1. Remove electrical power supplied to the fryer.

2. Support control panel bottom with one hand , loosen retaining screw at panel top, slide panel down slightly to clear screw, push panel back up, then swing panel top out and down.

   

3. Pull wires from breaker.

4. Using a multimeter or continuity light, check across terminals; circuit should be closed. If not, replace breaker.

Replacing

1. Open left door.

2. Use a 9/16 inch wrench and loosen the nut securing the breaker from underneath.

3. Pull the breaker from the control panel area.

4. Install new breaker in reverse sequence.

5. Support control panel bottom with one hand, swing panel top up about 90 degrees, slide panel down slightly to clear screw head, push panel top up to engage screw, then tighten screw.