Replacing the Nylatron Slides (Cam Slide Filler)

Raise the lid and remove the retention ring from one end of the lid pin.

Slide the lid pin from unit.

Lift the lid from unit.

Using a 3/8 inch socket, remove the nuts securing the rear shroud and remove shroud.

Using a crosshead screwdriver, remove the screws securing the top cap and remove top cap.

Remove the bolts securing the nylatron strips to the weight assembly and remove strips from weight assembly.

Using a crosshead screwdriver, remove the screws securing the front shroud.

Unfasten the exhaust hose from the hose clamp.

Lift the front shroud up and out, over the arm of the lid.

Thread the new nylatron strip through the track in the front shroud.

Lining up the holes in the strips, fit the front shroud back over the lid arms.

Secure the strips to the weight assembly.

Replace back shroud, top cap, and lid, and replacement is complete.