Installing the Power Cord

CE units require a minimum wire size of 4mm to be wired to the terminal block. If a flexible power cord is used, it must be HO7RN type.

To install the power cord, follow these procedures:

To avoid electrical shock or property damage, move the power switch to OFF and disconnect power.

To avoid personal injury, do not move fryer or filter pan while containing hot oil. The filter pan must be as far back under fryer as it will go, and the cover in place. Be sure the hole in the cover lines up with the drain before opening the drain.

1. Remove the side panel from the right side of the unit.

2. Remove the front panel, behind the filter knob and quick disconnect.

3. Thread the cable through the strain relief on the junction box.

4. Attach the wires to the terminal block according to the wiring diagram on the side panel.

5. Pull the slack out of the cable and tighten the screws on the strain relief.

6. Pull the slack out of the cable and secure it with the clamp on the back of the vat.

   Be sure the cable doesn’t sag, or it could interfere with the use of the portable filter.

7. Pull the slack out of the cable and secure it with the clamp on the frame, at the rear, right leg of fryer.

   Wiring the fryer is now complete.