Daily Filtering

To avoid personal injury: Use PPE Do not exceed the oil capacity of the shuttle (1 vat).

The shuttle holds 1 full vat, or 2 split vats of oil.

Check Filter Pan

The filtering procedure allows for a more thorough cleaning of the vat and should be done once a day. The vat can be filtered during any non-frying times.

1. A new filter envelope should be used on the first filter of each day, but the same filter envelope can be used the rest of the day.

2. Ensure that the filter pan cover is in place, filter tube is secured and filter filter pan is pushed into place. If the filter pan and cover are not latched the display will show "CHK PAN".

3. Press and hold the downward triangle button and display will show "2.DAILY FILTER?".

4. Press "1" button and display will show "CONFIRM" and "YES NO".

5. Press "1" button again for yes and "OPEN DRAIN" will show.

   

6. Pull-out on the drain knob and the display will show "DRAINING" and oil will drain from the vat. Pressing "3" button will return controls to normal operation.

   

7. Once oil has been drained from vat, remove basket support from vat.

8. Scrape or brush the sides and the bottom of the vat. Be careful to not damage the sensing probes.

9. Once the vat is clean and the display shows "SCRUB VAT COMPLETE?". Press "1" button and display will show "WASH VAT" "YES NO".

10. Press "√" button and it will display "WASHING" oil will then circulate through the vat for several minutes.

11. Once wash cycle is complete "WASH AGAIN" "YES NO" will display.

12. Press "1" button if another wash is needed, otherwise press "3" button. "CLOSE DRAIN" will display, push in on drain knob to close drain. The vat will then fill with oil.

13. Once vat is filled pull out on the drain knob to open the drain. Display will show "RINSING", when complete the unit will ask to rinse again.

14. Press "1" button if another rinse is needed, otherwise press "3".

15. The unit will display "POLISH" "YES". Press "1" button for yes and oil will be polished by circulating it through the filtering system. The display will show "5:00 NO=STOP" if desired press "3" to stop the polishing. Otherwise the oil will be polished for 5 minutes.

16. Once the oil is polished the display will show "FILL VAT?".

17. Press "1" button to fill vat.

    

18. Push in on the drain knob to close drain. Vat will then re-fill with oil.

19. Once full display will show "IS POT FILLED?". Press "1" button to return to normal operation.

20. If "3" button is pressed, display will show "FILLING". After trying to fill the vat 4 times the control will show "ADD QUIT" press left clock button and JIB pump will run for 60 seconds filling the vat from the oil reserve.

21. When vat is full, press right clock button and display will show "IS POT FILLED?". Press "1" button and fryer will return to normal operation.