Applies to:
AIF Board Replacement
Suggested Content
|
To avoid electrical shock or property damage, move the power switch to OFF and disconnect power. |
-
Ensure power is removed from the fryer.
-
Use a cross-tip head screwdriver to remove the two screws in the front of the control panel.
-
Remove the right-side panel to access the AIF board.
-
Use a cross-tip head screwdriver to remove the right-front sheet metal shroud. This contains the AIF board.
-
Take note of the locations of the wire connectors on the AIF board.
-
One by one remove the connectors form the old AIF board and plug them into the new AIF board.
-
Use a cross-tip head screwdriver to install the right-front metal shroud. This contains the new AIF board.
-
Use a cross-tip head screwdriver to install the side panel(s).
-
Test the new part to ensure it works properly.
