Applies to:
Filter Pan Microswitch Replacement
Suggested Content
|
To avoid electrical shock or property damage, move the power switch to OFF and disconnect power. |
-
Ensure the oil is drained from the vat and filter pan.
-
Remove the filter pan.
-
Remove power from the fryer.
-
Use a wrench or ratchet with socket to remove 10-24 serrated edge lock nuts from beneath the drain switch.
-
Pull the drain switch out of the back of the fryer, and then disconnect the lead wire by separating the pin connector.
-
Remove the frame wire ties as necessary to completely remove the drain switch.
-
Bolt the new drain pan switch in place but leave it loose.
-
Insert the drain pan back in to the fryer.
-
Adjust the drain switch so it is fully engaged.
-
Tighten both 10-24 serrated edge lock nuts, from beneath the drain switch to snug (zero torque), and then add 1/4 to 1/2 half turn with a wrench.
-
Connect the pin connector.
-
Install the frame wire ties as necessary.
-
Test the new filter pan switch to ensure it works properly.
