Applies to:

Replacing the Solenoid Valve and Water Strainer

To avoid electrical shock or property damage, disconnect power before installing or servicing equipment. A qualified technician must perform the service procedures.

HOT WATER

To avoid burns, use PPE when handling overflow tube and draining unit.

While wearing heat resistant gloves or using a grasping tool, remove overflow tube and allow water to drain from pan.
Remove screws and lower access panel from rear of unit.
Disconnect lead wires from solenoid valve.
Using a flat blade screwdriver, loosen hose clamp and remove hose from barb fitting.
Using a crosshead screwdriver, remove 4 screws and remove bracket, valve, and strainer assembly from under cabinet.
Using a crosshead screwdriver, remove 2 screws and valve.
Using a 1" wrench, loosen bulkhead adapter nuts and remove bracket.
Disassemble parts as needed to repair or replace strainer or valve.
Reassemble repaired parts and install in reverse order.