Replacing the Float Switch
Required tools
crosshead screwdriver
|
To avoid electrical shock or property damage, move the power switch to OFF and disconnect power. |
-
Remove electrical power supplied to the cabinet.
-
Drain the water pan by removing the drain standpipe.
-
Remove the control side end panel.
-
Cut float switch wires just behind switch.
-
From inside end channel, remove nylon fitting by unscrewing from float switch.
-
Remove float switch.
-
Install a new float switch in reverse order. Make sure float switch is located in center of hole and silicone washer is positioned properly.
NOTICE -
Tighten the float switch nut finger tight only! Overtightening the nut damages the float switch.
Maximum torque not to exceed 3 ft pounds.
-
Strip the wire ends that were cut, as well as the wire ends on the new float switch. Reconnect wires using wire nuts.
-
Replace end panel.
-
Turn on the power supply at the breaker box.
