Applies to:

Replacing the Filter Motor Relay

This component is located behind the left control panel and regulates voltage to the filter motor.

To avoid electrical shock or property damage, move the power switch to OFF and disconnect power.

  1. Hinge-down the left control panel.

  2. Label and remove wires from relay.

  3. Using a 5/16 inch wrench, remove the nuts securing the relay and remove relay from fryer.

  4. Install new relay in reverse order.

Related Content

Cleaning the Oil Channel

Replacing the Solenoid Valves

Replacing the Flange Mount Filter Pump and Motor

Replacing the JIB Pump

Replacing the Filter Pan Switch

Replacing the Filter Beacon

Adjusting the Drain Valve Actuator

Troubleshooting the Check Pan Message on Evolution Elite Fryers

Replacing the EEG Fryer Generation 4 Selector Valve Motor

Manually Cycling the Solenoid

Troubleshooting EEG 15X E-15 Drain Open Error Code

Troubleshooting EEG 15X Oil Not Pumping Error Code

Reference

EEG 15X Specifications

Error Codes

EEG 15X Wiring Diagrams

EEG 15X Plumbing Diagram