Applies to:

Replacing the Blower

To avoid electrical shock or property damage, move the power switch to OFF and disconnect power.

  1. Remove electrical power supplied to the unit.

  2. Remove the lower back shroud.

  3. Using a crosshead screw, remove the two screws that secures the blower to the flue. One screw is located on the back side of the flue.

  4. Cut zip ties that are holding the wires to the blower. Remove the wire nuts from the wires.

  5. Remove blower.

  6. Reconnect new blower wires to the existing wires with wire nuts.

  7. Tighten the new blower onto the flue with the two screws.

  8. Zip tie wires back to the blower.

Related Content

Replacing the High Temperature Limit Control

Replacing the Temperature Probe

Replacing the Blower Wheel

Replacing the Air Pressure Switches

Replacing the Pilot

Replacing the Main Power Switch

Replacing the Pressure Switch

Troubleshooting EEG 25X E-4 Control Overheating Error Code

Troubleshooting EEG 25X E-5 Oil Overheating Error Code

Troubleshooting EEG 25X E-6 Temperature Probe Failure Error Code

Troubleshooting EEG 25X E-10 High Limit Error Code

Troubleshooting the EEG 25X E-18 Level Probe Failure Error Code

Troubleshooting EEG 25X E-20A Fan Sensor Stuck On Error Code

Troubleshooting EEG 25X E-20B No Draft Check Fan Error Code

Troubleshooting EEG 25X E-20D Ignition Failure Error Code

Troubleshooting EEG 25X E-22 No Heat Error Code

Reference

EEG 25X Specifications

Error Codes

EEG 25X Plumbing Diagram