Applies to:
Replacing the Pilot
|
To avoid electrical shock or property damage, move the power switch to OFF and disconnect power. |
-
Remove electrical power supplied to the unit.
-
Lower the control board.
-
Remove the flame sensor wire from the red insulated terminal(1).
-
Remove the two screws securing the pilot to the burner assembly (2). The right hand screw will have the ground wire.
-
Disconnect the pilot wire (3) located in the orange rubber sleeve.
-
Using a 7/16 inch wrench, loosen the pilot tube from the pilot.
-
Replace pilot in reverse order.
-
When screwing the pilot back to the burner assembly, be sure to connect the ground wire to the right hand screw.
Related Content
Replacing the High Temperature Limit Control
Replacing the Temperature Probe
Replacing the Air Pressure Switches
Replacing the Main Power Switch
Troubleshooting EEG 25X E-4 Control Overheating Error Code
Troubleshooting EEG 25X E-5 Oil Overheating Error Code
Troubleshooting EEG 25X E-6 Temperature Probe Failure Error Code
Troubleshooting EEG 25X E-10 High Limit Error Code
Troubleshooting the EEG 25X E-18 Level Probe Failure Error Code
Troubleshooting EEG 25X E-20A Fan Sensor Stuck On Error Code
Troubleshooting EEG 25X E-20B No Draft Check Fan Error Code
Troubleshooting EEG 25X E-20D Ignition Failure Error Code
Troubleshooting EEG 25X E-22 No Heat Error Code
Reference
