Applies to:
Replacing the Main Power Switch
|
To avoid electrical shock or property damage, move the power switch to OFF and disconnect power. |
-
Lower the control board.
-
Press on the switch from the inside of the fryer to release from the metal shroud.
-
Mark and disconnect the wires from the switch.
-
Connect the wires onto the new switch on the correct terminals.
-
Press back into factory location.
Related Content
Replacing the Control Panel and Menu Card
Smart Touch Software Installation Instructions
Troubleshooting EEG 25X E-41 Programming Settings Lost Error Code
Troubleshooting EEG 25X E-60 AIF Communication Failure Error Code
Replacing the High Temperature Limit Control
Replacing the Temperature Probe
Replacing the Air Pressure Switches
Troubleshooting EEG 25X E-4 Control Overheating Error Code
Troubleshooting EEG 25X E-5 Oil Overheating Error Code
Troubleshooting EEG 25X E-6 Temperature Probe Failure Error Code
Troubleshooting EEG 25X E-10 High Limit Error Code
Troubleshooting the EEG 25X E-18 Level Probe Failure Error Code
Troubleshooting EEG 25X E-20A Fan Sensor Stuck On Error Code
Troubleshooting EEG 25X E-20B No Draft Check Fan Error Code
Troubleshooting EEG 25X E-20D Ignition Failure Error Code
Troubleshooting EEG 25X E-22 No Heat Error Code
Reference
