Applies to:

Replacing the Filter and JIB Lights

To avoid electrical shock or property damage, move the power switch to OFF and disconnect power.

  1. Remove control panel.

  2. Locate wires to light and cut wires.

  3. Using a 13/16 inch, deep-well socket (see photo at left) remove nut on the back side of the panel and pull the light from front of the panel.

  4. Install new light with deep-well socket, connect wires with wire nuts and reinstall the control panel.

  5. Restore power to the unit.

Related Content

Replacing the Solenoid Valves

Replacing the Drain Valve Actuator

Replacing the Filter Pump and Motor

Replacing the JIB Pump

Replacing the AIF PC Board

Replacing the Filter Motor Relay

Replacing the Filter Pan Switch

Replacing the Oil Level Probes

Replacing the Check Valve

Reference

Error Codes

Specifications

LVE 100 Plumbing Diagrams

LVE 100 Wiring Diagrams