Replacing the Pressure Regulation and Exhaust Components

Condensation Box Assembly

The deadweight valve and solenoid exhaust are directed into a condensation box located in the rear of the fryer. Should this box become clogged, water would spew from the top of the box. The box can be cleaned by running a wire or long brush from the top of the box, through the hole in the bottom of the box. The bottom of the box can be removed to clean.

To avoid electrical shock or property damage, move the power switch to OFF and disconnect power.

Condensation Box Bottom Removal

1. Loosen fitting at the bottom of the box.

   

2. Use a cross-tip screwdriver to remove 4 screws securing the bottom of the box and pull bottom from assembly.

3. Clean outlet hole in box bottom and check condensation tube for clogs. Clean if necessary.

4. Reinstall box bottom and condensation line.

5. Seal box bottom with silicone sealant and unit is now ready for operation.