Applies to:

Resetting, Checking and Replacing the Breaker

Resetting the Breaker

There are four breaker on the electric fryers. To reset the breaker, open the left door and locate breakers behind drain knob plate. Push on the plunger on the breaker to reset.

Checking the Breaker

To avoid electrical shock or property damage, move the power switch to OFF and disconnect power.

Remove the left control panel and pull the wires from the breaker.
Using a multimeter or continuity light, check across the terminals. The circuit should be closed. If not, replace the breaker (HP# EF02-125).

Replacing the Breaker

To avoid electrical shock or property damage, move the power switch to OFF and disconnect power.

To replace breaker, remove left control panel and pull wires from breaker.
Use a 9/16 inch wrench and loosen the nut securing the breaker from underneath and then pull the breaker from the control panel area.

Replacing the Main Power Switch

Installing the SiteSage Radio Hardware

Replacing the Express Filter PC Board

Smart Touch Software Installation Instructions

Troubleshooting Blank Display

Troubleshooting EEE 14X E-41 Programming Settings Lost Error Code

Troubleshooting EEE 14X E-60 AIF Communication Error Code

Replacing the High Limit

Replacing the Temperature Probe

Replacing the Element Safety Switch

Replacing the Contactors

Replacing the Transformers