Replacing the Control Panel and Menu Card

Should the control panel become inoperative, or the menu card needs changed, follow these instructions:

To avoid electrical shock or property damage, move the power switch to OFF and disconnect power.

1. Remove electrical power supplied to the vat.

2. Remove the two screws securing the control panel.

3. Pull the top of the panel down, allowing the panel to be supported by the 2 brackets in the slots in the control shroud. (If changing control panel, continue onto step 5.)

4. If changing the menu card, loosen the tape securing the menu card at the bottom side of the control panel and pull menu card from panel. Carefully slide changed menu card back into slot in panel and secure with tape.

5. Unplug the connectors going to the control board.

6. Install a new control panel in reverse order.