Replacing the High Temperature Limit Control

To avoid electrical shock or property damage, move the power switch to OFF and disconnect power.

  1. Remove electrical power supplied to the unit.

  2. Lower the control board.

  3. Using a 5/16 inch wrench, remove the two nuts connecting the heat shield covering the high limit control.

  4. Mark and disconnect the wires located on the high limit control.

  5. Using a 3/8 inch wrench, remove the nuts.

  6. Remove the clamp bars.

  7. Using a 5/16 inch wrench, remove the two nuts on the high limit bracket and then slide the high limit control off of mounting studs.

  8. Install the new control in reverse order.

Related Content

Replacing the Main Power Switch

Replacing the Temperature Probe

Replacing the Blower

Replacing the Blower Wheel

Replacing the Air Pressure Switches

Replacing the Pilot

Troubleshooting the Solid State High Limit

Replacing the Pressure Switch

Troubleshooting EEG 16X and 24X E-5 Oil Overheating Error Code

Troubleshooting EEG 16X and 24X E-6 Temperature Probe Failure Error Code

Troubleshooting EEG 16X and 24X E-10 High Limit Error Code

Troubleshooting EEG 16X and 24X E-20A Fan Sensor Failure Error Code

Troubleshooting EEG 16X and 24X E-20B No Draft Check Fan Error Code

Troubleshooting EEG 16X and 24X E-20D Ignition Failure Error Code

Troubleshooting EEG 16X and 24X E-22 No Heat Error Code

Reference

Specifications

Error Codes

EEG 16X and 24X Plumbing Diagram

EEG 16X and 24X Wiring Diagrams