Applies to:

Replacing the Pilot

To avoid electrical shock or property damage, move the power switch to OFF and disconnect power.

Remove electrical power supplied to the unit.
Lower the control board.
Remove the flame sensor wire from the red insulated terminal(1).
Remove the two screws securing the pilot to the burner assembly (2). The right hand screw will have the ground wire.
Disconnect the pilot wire (3) located in the orange rubber sleeve.
Using a 7/16 inch wrench, loosen the pilot tube from the pilot.
Replace pilot in reverse order.
When screwing the pilot back to the burner assembly, be sure to connect the ground wire to the right hand screw.