Replacing the Filter Pan Switch

This switch closes when the filter pan is pushed properly in place under the fryer. If the filter pan is not properly in place, or the drain switch is faulty, display prompts such as, “CHECK PAN”; “CHANGE FILTER PAD” shows in the display.

To avoid electrical shock or property damage, move the power switch to OFF and disconnect power.

Checkout

1. Remove control panel and hinge it down.

2. Locate the 8-pin connector on the AIF PC board and pull the connector from the board.

3. Check for normally open circuit between pins with wires labeled D1 & D2.

   If the circuit shows closed, continue with the replacement instructions below.

Replacing

1. Filter pan switch is located on the rear of fryer. Using a 3/8 inch socket or nut driver, remove the nuts securing the drain switch bracket to the fryer.

   

2. Using a 1/8 inch Allen wrench, remove shoulder bolt securing the cover and remove cover.

   

3. Using a crosshead screwdriver, remove screws securing switch to bracket and remove switch.

   

4. Label and remove wires from switch.