Replacing the Filter Beacon

To avoid electrical shock or property damage, move the power switch to OFF and disconnect power.

  1. Remove right or left side panel for end vats, or hinge-down the control panel for center vats.

  2. Pull apart the light by pulling on the rear of the light and removing the front part of the light from the front of the fryer.

  3. Locate and cut the light wires and pull the light from unit.

  4. Connect new light wires using wirenuts, and install light in reverse order.

  5. Restore power to the unit.

Related Content

Replacing the Solenoid Valves

Replacing the Selector Valve Motor Encoder

Replacing the JIB Pump

Replacing the Flange Mount Filter Pump and Motor

Replacing the Hubmounted Filter Pump and Motor

Adjusting the Drain Valve Actuator

Troubleshooting Oil Not Pumping

Replacing the Bulk Fill Selector Valve

Replacing Drain Switch

Troubleshooting the Check Pan Message on Evolution Elite Fryers

Replacing the EEG Fryer Generation 4 Selector Valve Motor

Manually Cycling the Solenoid

Troubleshooting EEG 16X and 24X E-15 Drain Open Error Code

Troubleshooting EEG 16X and 24X E-18 Level Probe Failure Error Code

Troubleshooting EEG 16X and 24X Oil Not Pumping Error Code

EEG E 82D Error Code Troubleshooting

Adjusting the Filter Pan Limit Switch

Reference

Specifications

Error Codes

EEG 16X and 24X Plumbing Diagram

EEG 16X and 24X Wiring Diagrams