Applies to:

Tighten Heat Probe and Element Spreader Bars

Tighten the heating element spreader bar bracket and heat probe screws, every 90 days as follows:

  1. Obtain a 1/4 in. nut driver or wrench.

  2. Snug each screw, being careful not to over-tighten.

Related Content

Component Overview

Basic Operation

Purging Oil Lines

Filling or Adding Oil

Express Filter

Daily Filter

Setting Up Bulk Oil Disposal

Discarding Oil Using Front Dispose

Discarding Oil Using Rear Dispose

Discarding Oil Using Rear RTI Dispose

Discarding Oil Using Cart Dispose

Maintenance Schedule

Cleaning the Filter Pan Assembly

Replacing the Filter Pan Lid Gasket

Deep Clean

Reference

Specifications

Error Messages

LVE 300 Plumbing Diagrams

LVE 300 Wiring Diagrams

LOV 3 Service Video Archive

LVE 300 Software (without Connectivity)

LVE 300 Software (Connectivity)

100 Ohm Chart