Replacing Condensation Box Assembly

To avoid personal injury or property damage, before starting this procedure, move the main power switch to the off position. Disconnect the main circuit breakers at the circuit breaker box or unplug service cord from wall receptacle. Turn off the main gas supply to the fryer and disconnect and cap the main supply line to fryer, or possible explosion could result.

Condensation Box Assembly

The deadweight valve and solenoid exhaust are directed into a condensation box located in the rear of the fryer. Should this box become clogged, water would spew from the top of the box. The box can be cleaned by running a wire or long brush from the top of the box, through the hole in the bottom of the box. The bottom of the box can be removed to clean.

Condensation Box Bottom Removal

1. Loosen fitting at the bottom of the box.

   

2. Use a cross-tip screwdriver to remove 4 screws securing the bottom of the box and pull bottom from assembly.

3. Clean outlet hole in box bottom and check condensation tube for clogs. Clean if necessary.

4. Reinstall box bottom and condensation line.

5. Seal box bottom with silicone sealant and unit is now ready for operation.

1. Adjust the limit stop by turning it clockwise until it stops against the bottom hub of the spindle.

2. Tighten Allen set screws.

3. If the lid cover fails to seal properly, steam will escape around the gasket during the frying operation. The limit should be readjusted. This time turn the spindle screw one full turn after the initial contact of the lid gasket against top of the vat rim.