Replacing the Base Heater
Required tools
3/8” socket
crosshead screwdriver
|
To avoid electrical shock or property damage, disconnect power before installing or servicing equipment. A qualified technician must perform the service procedures. |
-
Remove pans and pan supports from unit.
-
Remove cross head screws from heater bracket.
-
Using a 3/8” wrench or socket, remove the acorn nut securing the heater brace and remove brace.
-
Remove the crosshead screws securing the bottom, rear cover and let hinge down.
-
Pull wires from heater and pull heater from unit.
Using a multimeter, or ohm meter, check ohm rating without the wires connected. The ohm ratings: 208V - Hot - 66.5 ohms; Cold - 60.2 - 89.7 ohms 240V - Hot - 88.6 ohms; Cold - 80.1 - 92.8 ohms
-
Install new heater in reverse order.
