Replacing the Power Switch
|
To avoid electrical shock or property damage, move the power switch to OFF and disconnect power. |
-
Remove the control board.
-
Use a flat-blade screwdriver to press down on the locking tabs.
-
Pull the old switch out of the shroud, and then disconnect the wires.
-
Attach the wires to the new switch, and then slide new power switch into the shroud.
-
Reinstall the control board.
-
Test the operation.
Related Content
Replacing the Primary Contactor
Replacing the AIF Multi-Tab Transformer
Replacing the Control Transformer
Troubleshooting the Zigbee Radio
ZigBee Radio Communication Kit
Menu Card Removal Replacement Instructions
Save and Load Setpoint Instructions
PXE 100 Troubleshooting the E-41 Programming Settings Lost Error Code
Reference
Product Racking Recommendations
PXE 100 Inspection and Planned Maintenance
