Troubleshooting the SPU Display
Overview
If the cleaning program is canceled, rinsing of the cooking zone may occur automatically. "SPU" appears on the left display.
The center display shows the selected cleaning level.
The right display shows the remaining time.
After the automatic rinse time has elapsed, the displays change.
Procedure
Avoiding automatic forced rinse:
-
Do not cancel cleaning manually after 10 minutes of cleaning.
-
Do not switch the combi off and back on during cleaning.
Cleaning is canceled automatically in the event of an error.
What to do if an automatic forced rinse occurs:
Wait for the cleaning cycle to complete.
If the automatic forced rinse is canceled, it starts again from the beginning.
It is not possible to start a cooking program before the forced rinse run to completion.
Concept Information
Related Content
FlexFusion Platinum Combiovens
Troubleshooting a Blank Display on FlexFusion Team Combi Ovens
Unlocking and Deactivating the Lock Screen on FPE and FPG Combi Ovens
Repairing the CombiOven Door Seal
Troubleshooting FPE CombiOven Without Heat, Error Message, or Voltage
FlexFusion Platinum 701 / 702 Fan Defective Error Message
Changing a Standard Six or Ten Grid Gas Unit into a Stacked, Bottom Unit
Setting Up the Grease Collection System
Reference
FlexFusion Platinum Electric G1 Combiovens
FlexFusion Platinum Electric G2 Combiovens
FlexFusion Platinum Gas G1 Combiovens
FlexFusion Platinum Gas G2 Combiovens
Flexfusion Platinum Gas 221 CombiOven
FlexFusion Platinum Team Combiovens
CombiOven Service Video Archive
