Applies to:
Replacing the Filter Pump Motor Seal
|
To avoid electrical shock or property damage, move the power switch to OFF and disconnect power. |
The filter pump and filter motor must be seperated for this procedure, see Replacing the Filter Pump Motor. The oil seals prevent oil from migrating into the motor assembly, which can damage the motor. With the new filter motor on a flat sturdy work surface, using seal kit 17476, install the pump seal components on to the new filter pump motor as shown.
Related Content
Replacing the Filter Pump Motor
Replacing the Filter Pump Motor Rollers
Replacing the Selector Valve Motor and Encoder
Replacing the Drain Valve and Actuator
Replacing the Nylatron Vertical Strip
Velocity Nylatron Vertical Filler Strips Installation Instructions
Selector Valve Motor/Encoder Replacement
Velocity Deadweight Orifice Clean-out Tool Installation and Maintenance
Velocity Lid Cable Replacement
Instructions to replace PXE Interlock Latch Pivot Pin
Front Dispose Addition (for Bulk Oil Units)
Remove Selector Valve to ATO flex tube
Flexible Line Replacement Kit (Formed Tube), (Standard, Bulk-Oil Fryer)
Flexible Line Replacement Kit (Formed Tube), (Standard, NON Bulk-Oil Fryer)
Reference
