Applies to:
Testing Thermostat
|
To avoid electrical shock or property damage, move the power switch to OFF and disconnect power. |
If the thermostat fails to work properly, perform the following checks before replacing the thermostat
-
Remove electrical power supplied to the fryer.
-
Remove the control panel.
-
With an ohmmeter or continuity light, check for continuity.
-
To check continuity on a standard temperature thermostat, check between terminals 52 and 53. Move the temperature knob from off to maximum.
-
At off position, the circuit should be open. At maximum, the circuit should be closed.
Related Content
Replacing the High Temperature Limit Control
Checking the Temperature Probe Calibration for Chick-fil-A
Replacing the Temperature Probe
Calibrating The Standard Single Stage Thermostat
Replacing the Gas Burner Assembly
Replacing the Main Power Switch
PFG 600 SSI Fryers Gas Valve Replacement Kit
Direct connect retrofit PFG 600
Direct connect retrofit PFG-600
PFG 600 Ignition Module Retrofit Kit
Temperature Probe Gauge Instructions
Troubleshooting E-1 Frypot Protection System (FPS)
Troubleshooting the PFG 600 E-12 FPS Probe Failure Error Code
Troubleshooting Oil Melting or Heating Slowly
Troubleshooting the PFG 600 E-20C No PV Error Code
Troubleshooting the PFG 600 E-20D Ignition Failure Error Code
Troubleshooting the PFG 600 E-92 24V Fuse Error Code
Reference
