Installing SCR Bumper
Estimated Time
30 Minutes
A bumper must be used on rotisseries with mirrored door glass installed on the customer side. This bumper ensures 3 inches clearance from a rear wall.
-
Lay unit on it’s side and bolt locking casters or legs, to the control side of unit.
-
Use the bolts provided for the non-locking casters, or legs, bolt both the bumper and the non-locking caster, or legs, to the front side of the unit.
-
The bumper should extend out the front of the unit about three inches.
-
Carefully lift the rotisserie upright, onto the casters.
Related Content
Replacing the Drive Motor Capacitor
Replacing the Meat Probe Receptacle
Testing the Relay and Replacing the Drive Motor
Installing the Rotation Switch
SCR Stacking Kit Instructions Short
Rotisserie Stacking Instructions
Troubleshooting a Broken Shaft Adapter Pin
Radiant Heat Deflectors Instructions
Radiant Heat Deflectors Instructions
SCR 6/8 Lamp Guard Installation Instructions
Reference
