SCR 8 Diffuser Kit

All instructions are referenced from the control side of the Rotisserie.

1. Remove the right hand side removable duct by gently lifting the duct and guiding it out. This part will be reused.

2. Remove the left hand side duct in the same fashion described above. This part will not be reused.

3. Remove the upper duct by pushing the duct straight up and then towards the right hand side until pin disengage from the duct’s slots. This part will not be reused.

4. Remove the screw securing the existing heater support bracket located on the right hand side of the unit and remove the bracket. Remove all three heater support brackets. The brackets will not be reused but the fasteners will be reused.

5. Remove the center screw on each of the three heater mounting plates. These screws will be reused.

6. Install the three heater support brackets supplied with this kit use the previous fasteners

7. Install the left hand air duct baffle use the previous fasteners

8. Insert the air divider insert into the top air diffuser duct as shown in the picture below by sliding the air divider into the air duct.