SCR 6/8 Lamp Guard Installation Instructions

Kit number

14345

14346

Estimated Time

1 Hour

To avoid electrical shock or property damage, move the power switch to OFF and disconnect power.

Remove light deflector and heater support bracket on customer side of rotisserie. Light deflector and support bracket are held in place with (3) Crosstip head screws.
Pay close attention to light deflector orientation. The replacement light deflector assembly must be installed with the same orientation.
Remove (3) screws from the plate connected at the base of the radiant heater and carefully lower heater.
Do not disconnect electrical connections on heater. Save heater bracket and all screws. You will use them to install replacement light deflector assembly in next step.
Select the replacement light deflector for the customer side of the rotisserie. (Select control-side light deflector assembly for control side of rotisserie).
Install replacement light deflector assembly and heater support bracket and fasten with (3) screws from previous step, Re-attach radiant heater using (3) screws.
With the mesh screens facing downward and (2) studs pointed toward rotisserie, install mesh screen assembly.
Ensure certain studs pass through clearance holes on light deflector. While holding screen assembly in place, slide one of the latches toward stud into the locked position.
Slide the other latch into the locked position.
Repeat steps to install the control-side light deflector assembly and lamp guard