Radiant Heat Deflectors Instructions

Removing The Current Deflectors

1. Locate the current Deflectors on the inside of the SCR-8 unit.

2. Locate the 6 screws (3 for each deflector) that secure the deflectors in place.

3. Remove the screws and remove the deflectors from the Rotisserie unit.

Installing the P/N 56417 Baffle - Air Duct - Rot

1. Remove the side air duct on control panel side of unit.

2. Remove the upper air duct from the unit.

3. Locate the heater mounting plates in the ceiling opposite of the control side of the cabinet.

4. Remove the center screw on each of the heater plates, for each of the three heaters.

5. Align the three holes on P/N 56417 with the hole that the screws were removed from.

6. Tightly secure the Baffle using three of the screws into the existing holes in the heater plates.

Installing Deflector - Light - Control

1. Before installing, be sure that you are on the CONTROL PANEL SIDE of the Rotisserie.

2. To identify, find the Deflector that has 2 arrows cut into it.

3. Place into the unit, making sure that the 2 arrows are pointing towards the control panel side door (pointing towards you, the installer). Line up the mounting holes from the previous Deflector. Tighten all fasteners securely.

Installing Deflector - Light Customer

1. Before installing, be sure that you are on the NON-CONTROL PANEL SIDE of the Rotisserie.

2. To identify, find the Deflector that has 1 arrow cut into it.

3. Place into the unit, making sure that the 1 arrow is pointing towards the non-control panel side door (pointing towards you, the installer). Line up the mounting holes from the previous Deflector. Tighten all fasteners securely.