Applies to:

Replacing the Fuse Holder

Fuse Holder

There are two fuse holders on each model of the electric fryers.

To avoid electrical shock or property damage, move the power switch to OFF and disconnect power.

Checking Procedure For Fuses

Control panel fuses 3 phase:

Check from #54 to #55 and #68 to #69 on fuse assembly. The circuit should be closed, if not, replace the fuse.

Cord and Plug Check

Perform a check on the cord and plug as follows: Test from each plug prong to the corresponding wire lead on the other end of the cord at junction box. The result should be a closed circuit on each line tested.

Wall Receptacle (Voltage Check)

Check the voltage across line L1 and L2. The voltage should correspond to the voltage shown on the data plate. If models have L3, check across L1 to L2, L2 to L3, and L1 to L3.

Related Content

Replacing the Indicator Lights

Lowering the Control

Replacing the Main Power Switch

Replacing the Timing Control

Auxillary Buzzer Kit

SMS Retrofit kit

Electronic C2000 Simple Control Retrofit Kit

RLink programming instructions

PFE 500/PFG 600 Hybrid Control Installation Instructions

PFE 500/PFG 600 Wi-Fi Verification and Troubleshooting Instructions

FAST Control Installation Instructions