Applies to:
RLink programming instructions
Estimated Time
15 Minutes
-
Connect the USB connector of the RLink programmer to the netbook and the other end to the fryer control.
-
Power up the netbook.
-
Double click the WinFlink icon on the desktop to launch.
-
Click the "Browse" button in the top right corner.
-
Select the drop down box at the top to choose "Desktop".
-
You will see a folder named "HPProg", open it and select the "hp97229.jfc" file.
-
Click the "Execute" button. Flashing can take anywhere from 15 to 60 seconds. Watch the bottom of the window for "Log information" to state when flashing is completed.
-
Once completed, click "Close" to exit WinFlink.
-
Disconnect the RLink programmer from the control and the netbook.
Related Content
Replacing the Indicator Lights
Replacing the Main Power Switch
Electronic C2000 Simple Control Retrofit Kit
PFE 500/PFG 600 Hybrid Control Installation Instructions
PFE 500/PFG 600 Wi-Fi Verification and Troubleshooting Instructions
FAST Control Installation Instructions
2nd Generation Radio for SMS: Hardware Installation
2nd Generation Radio for SMS: Software Update
FM08-748 2nd Generation Radio for SMS: Troubleshooting
Instructions for Fryer Control Replacement Kits
SMS 20 Auto Polish Programming Instructions
Troubleshooting the SMS 20 Control Countdown
Direct connect oil system operating instructions
4 Head PFE 500/ PFG 600 Removing the Lid
Pressure Assist Kit Installation
Temperature Probe Gauge Instructions
Replacing the Indicator Lights
Replacing the Main Power Switch
Installation of PFG 600 and PFG 600 SSI FM07-366 Electromechanical to C1000 Retrofit
PFG 600 SSI Electronic C1000 to C8000 Retrofit Kit
Hybrid Control and Wi-Fi Installation
Direct connect retrofit PFG 600
Direct connect retrofit PFG-600
PFG 600 Ignition Module Retrofit Kit
PFG 600 SSI Fryers Gas Valve Replacement Kit
SAE Thread Filter Pump Installation
Pre VA SAE Thread Filter Pump Installation
Reference
PFE 500 and 561 Inspection and Planned Maintenance
PFE 500 KFC Annual Inspection Certification
