Applies to:
Replacing the Indicator Lights
|
To avoid personal injury or property damage, before starting this procedure, move the main power switch to the off position. Disconnect the main circuit breakers at the circuit breaker box or unplug service cord from wall receptacle. |
The indicator lights for HEAT-PUMP-POWER, are identical assemblies consisting of a neon light and mounting clip, and are replaced as assemblies.
-
Remove control panel.
-
Disconnect indicator light wires from the individual power source.
-
Squeeze the retaining clip while removing the indicator light and discard the light.
-
Install the new indicator light.
-
Connect the wires from the new indicator light.
-
Replace control panel.
Related Content
Replacing the Main Power Switch
Electronic C2000 Simple Control Retrofit Kit
Installation of PFG 600 and PFG 600 SSI FM07-366 Electromechanical to C1000 Retrofit
PFG 600 SSI Electronic C1000 to C8000 Retrofit Kit
RLink programming instructions
PFE 500/PFG 600 Wi-Fi Verification and Troubleshooting Instructions
PFE 500/PFG 600 Hybrid Control Installation Instructions
FAST Control Installation Instructions
2nd Generation Radio for SMS: Hardware Installation
2nd Generation Radio for SMS: Software Update
FM08-748 2nd Generation Radio for SMS: Troubleshooting
Instructions for Fryer Control Replacement Kits
SMS 20 Auto Polish Programming Instructions
Hybrid Control and Wi-Fi Installation
Troubleshooting the SMS 20 Control Countdown
Reference
