Applies to:
Securing Latch Pin Block
Required tools
9/16 in. Open end wrench
3/8 in. Ratchet drive with 5/32 in. hex bit and 3/8 in. drive
316 L Stainless steel welding filler rod
Adjustable wrench
Angle grinder
Crosstip head screwdriver
GTAW Welding torch and protection
Marker
Wire brush
Estimated Time
30 Minutes
|
Only perform this procedure when the unit is cool or severe burns may result. |
Procedure
-
Remove the two screws at the rear of the lid cover.
-
Tilt rear of lid cover up, then push toward the front of the fryer to remove the lid cover.
-
Ensure the latch pin block is mounted tight to the lid handle wedlment. If this is loose replace latch pin block.
-
Use gas tungsten arc welding (GTAW) with argon shield gas at 80-140 amps and a 316 L .062 in. stainless steel filler to fillet weld latch pin block top and bottom on the lid handle.
-
Use a wire brush to remove heat discoloration.
-
Replace lid cover and secure with two screws.
Related Content
Replacing the Nylatron Vertical Strip
Armored Cable Grounding Installation Instructions for Australia
Lid Latch Adjustment or Replacement
Velocity Steam Box Swap-out Instructions
Velocity Nylatron Vertical Filler Strips Installation Instructions
Lid Handle Replacement Instructions
Velocity Deadweight Orifice Clean-out Tool Installation and Maintenance
Velocity Lid Cable Replacement
Add pressure gauge to PXE unit Instructions (Japan / Hong Kong)
Instructions to replace PXE Interlock Latch Pivot Pin
Add pressure gauge to PXE unit Instructions
ZigBee Radio Communication Kit
Selector Valve Motor/Encoder Replacement
Front Dispose Addition (for Bulk Oil Units)
Remove Selector Valve to ATO flex tube
Temp/Level Probe Fitting Replacement
Label Replacement Instructions
High Limit Protection Probe Installation (CE Version built prior to 5/2020, ALL Versions after)
High Limit Protection Probe Installation (UL Version built prior to 5/2020)
Menu Card Removal Replacement Instructions
Save and Load Setpoint Instructions
Flexible Line Replacement Kit (Formed Tube), (Standard, Bulk-Oil Fryer)
Flexible Line Replacement Kit (Formed Tube), (Standard, NON Bulk-Oil Fryer)
Velocity High Limit Adjustment Instructions
Reference
Product Racking Recommendations
